To Set A Desired Speed; Deactivating Electronic Speed Control; To Resume Speed; Varying The Speed Setting - Dodge 2009 Ram Truck Owner's Manual

WARNING!
Leaving the Electronic Speed Control system on
when not in use is dangerous. You could accidently
set the system or cause it to go faster than you want.
You could lose control and have an accident. Always
leave the Electronic Speed Control system off when
you are not using it.

To Set a Desired Speed

When the vehicle has reached the desired speed, press
the SET lever downward and then release. Lift your foot
off the accelerator and the vehicle will operate at the
selected speed.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 161

Deactivating Electronic Speed Control

A soft tap on the brake pedal or pulling the Electronic
Speed Control lever (CANCEL) toward you will deacti-
vate the Electronic Speed Control without erasing the set
speed memory. Pushing the ON/OFF button to the OFF
position or turning OFF the ignition erases the set speed
memory.

To Resume Speed

To resume a previously set speed, raise the Electronic
Speed Control lever (RESUME/ACCEL) upwards and
release. Resume can be used at any speed above 30 mph
(50 km/h).

Varying The Speed Setting

When the Electronic Speed Control is SET, speed can be
increased by raising and holding the RESUME/ACCEL
lever upwards. When released, a new set speed will be
established.
3