Table of Contents
Advertisement
AIR DEFLECTOR AND GLASS DOOR INSTALLATION
INSTALLING AIR DEFLECTORS (42''
MODELS ONLY)
Slide air deflector in between the front side
face and side brick panel (see Figure 27).
The notched end of the deflector sits on
bottom hearth. Air deflector does not require
any fastening.
The front side faces and side brick panels will
hold the deflector in place (see Figure 27).
IMPORTANT: Install glass door
frame before installing glass door.
INSTALLING DOOR FRAMES
1. Remove screws from smoke shelf (see
Figure 26).
2. Mount top door frame and secure with
screws removed in step 1.
3. Remove center ash refractory by pulling
ring handle (see Figure 27).
4. Remove ash box.
5. Remove three screws located at front of
firebox (see Figure 27).
6. Align bottom rail mounting holes with
holes at front of firebox and secure with
screws removed in step 5.
7. Place ash box in place. Replace center
ash refractory.
Figure 26 - Installing Top Door Frame
Air
Deflector
Bottom
Door Rail
Ash Box
Center
Brick
Ring
Handle
Figure 27 - Installing Bottom Door Frame
and Air Deflectors
126604-01A
Top Door Frame
Smoke Shelf
Screws
www.SuperiorFireplaces.US.com
INSTALLING GLASS DOORS
Spring clips have been installed but some
adjustments may be needed. If doors do not
close properly or do not appear straight, see
Door Adjustment.
1. With bi-fold doors completely folded,
insert bottom pivot pin into pivot hole
located near bottom corner of front face
opening and swing door to vertical posi-
tion making sure top pins slide into door
track. Door is installed when top door pin
snaps into spring clip.
2. Repeat step 1 for remaining door.
If you find doors do not close properly or do
not appear level or straight, proceed with
section on door adjustment,
Fold Door
and Slide
Top Pins
Into Track
Figure 28 - Installing Bi-Fold Doors
DOOR ADJUSTMENT
Remove doors and slightly loosen lower pivot
clips and upper spring clips. Replace doors
and fully close them. Use 1/8" shims (any
material) to level doors. Once proper setting
is achieved, carefully open doors enough so
that you can access spring clips with a Phillips
screwdriver. Tighten screws. See Figure 29.
Figure 29 - Adjusting Bi-Fold Doors
Spring
Clip
Insert Pin
into Spring
Clip
Insert
Bottom
Pivot Pin
into Hole
Pivot
Hole
Spring
Clip
15
Advertisement
Table of Contents
