1. Manuals
  2. Brands
  3. Travis Industries Manuals
  4. Indoor Fireplace
  5. 1250 Insert
  6. Owner's manual

Travis Industries 1250 Owner's Manual

Wood insert
Hide thumbs Also See for 1250:
1
2
3
4
5
6

Advertisement

Table of Contents

1250 Wood Insert
•
Masonry Fireplace Insert
SAFETY NOTICE:
If this appliance is not properly installed, a house fire may
result. For your safety, follow the installation directions.
Contact local building or fire officials about restrictions and
installation inspection requirements in your area.
Travis Industries, Inc.
4800 Harbour Pointe Blvd. SW
Mukilteo, WA 98275
www.travisproducts.com
Owner's Manual
•
Save these instructions
for future reference
© Copyright 2011, T.I.
$10.00
100-01233_000
4110304
Zero-Clearance (Metal)
Fireplace Insert
Tested to: U.L. 1482 & ULC S628
Listed

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 1250 and is the answer not in the manual?

Questions and answers

Related Manuals for Travis Industries 1250

Summary of Contents for Travis Industries 1250

  • Page 1 1250 Wood Insert Owner's Manual • • Masonry Fireplace Insert Zero-Clearance (Metal) Fireplace Insert Save these instructions for future reference SAFETY NOTICE: If this appliance is not properly installed, a house fire may result. For your safety, follow the installation directions.

  • Page 2: Stove Installation

    13-1/2" 343mm 3" 77mm Figure 1 (a) Measure side and top clearances from the top plate. Measure front clearances from the stove face (b) Fireplace Opening Emissions 4.4 Grams Per Hour (EPA Phase II Approved) © Travis Industries 100-01233 4110304...

  • Page 3: Fireplace Requirements

    Attach the "This fireplace has been altered..." plate to the fireplace (use two screws or other suitable method). You may wish to place it in a location where it will be covered by the surround panels. © Travis Industries 100-01233...

  • Page 4: Insert Placement Requirements

    Extension Onto Hearth Figure 3 Hearth Requirements • Must extend 16" (USA) or 18” (Canada) in front of the insert and 8" on both sides. • Must be non-combustible and at least .018" thick (26 gauge) © Travis Industries 100-01233 4110304...

  • Page 5: Masonry Fireplace Requirements

    ") may be removed (if applicable). The masonry lining (" "), insulation (" "), and any structured rigid frame members (metal sides, floor, door frame, face of the fireplace, etc. – " ") may not be removed or altered Figure 4 © Travis Industries 100-01233 4110304...
  • Page 6 A block-off plate or other non-combustible sealing device (e.g. damper adapter) is required. It must seal the chimney to insure smoke does not enter the home while providing the chimney system with sufficient draft. Figure 7 © Travis Industries 100-01233 4110304...

Table of Contents