Smeg CW 420 User Manual page 16

- CW 420/430
Start-on/start-off
Set at "on" to start the cycle when the door is closed.
Set at "off" for cycle start after confirmation with the start
button
Water hardness setting (if featured), on models with
softener only
tStP on/off "on" = minimum rinsing temperature as set,
regardless of intake water temperature.
If the intake water is not hot; the cycle duration might be a
few seconds longer than the nominal timing, "off" = the
minimum rinsing temperature might be a few degrees
lower than the setting
Rinse aid pump total operating minutes display. (if
featured)
This value can be reset during pump maintenance - see
below.
Detergent pump total operating minutes display. (if
featured)
This value can be reset during pump maintenance - see
below.
Energy consumption (kW) display
The Pc option indicates the total kW consumed since
installation of the dishwasher or since the latest reset.
Display of the number of cycles performed
When scrolling through the appliance parameters, the "tc
88888" item will also appear; this is the count of the total
cycles performed by the dishwasher since installation.
This parameter cannot be modified or reset unless the
software is reprogrammed.
15