Transfer Pictures Failure; Wrong Paper Size; Print Troubleshooting - Kodak EasyShare 5500 User Manual

Chapter 9

Transfer Pictures Failure

Nothing happens when you try to transfer pictures to the computer.
Press the Transfer button, on the printer.
1
Check the power and USB connections from the printer to the computer.
2
If you are trying to transfer pictures from a memory card and a PictBridge camera is connected, remove
3
it.
Close unnecessary software applications, and minimize remaining application windows. Follow any
4
messages on the screen that may have been hidden by other windows.
Disconnect then reconnect the USB cable from the printer to the computer.
5
Make sure you are using the USB cable included with your printer.
6
Make sure Kodak EasyShare software is installed. Install if necessary. If you choose Custom installation,
7
make sure to install the printer driver.
Un-install, and then reinstall Kodak EasyShare software.
8
Make sure your computer meets the minimum system requirements. Upgrade your system if
9
necessary.
NOTE: The Kodak AiO printer is compatible with the Kodak 8-in-1-card reader (sold separately). Other
Kodak USB card readers may work with the printer; however, other manufacturers' card readers
are not supported.

Wrong Paper Size

The paper you selected does not match the active paper tray. The paper selected may be too large or too
small than the paper found in the paper tray.
Replace the paper in the paper tray with the correct type.
1
Press OK to continue or Cancel to exit.
2

Print Troubleshooting

Envelope Printing Incorrect
The envelopes are not loaded correctly.
Remove the envelopes from the main paper tray.
1
Straighten the stack of envelopes against a flat surface, and reload it into the main paper tray.
2
Slide the paper-width and paper-length guides inward until they stop at the edges of the envelopes.
3
132 Kodak EasyShare 5500 AiO