Table of Contents
Advertisement
O
4
PERATION
O
PERATION
4.1
OPERATOR CONTROL ELEMENTS
RMS
ADV ANCED
RMS LITE
INITIAL STATE
4.2
Monitoring System
Rack Monitoring System
1
2
1
Note
LINDY RMS
N: RMS
L:Rechenzentrum
C: Fred Clever
I192.168.018.103
N255.255.255.000
B192.168.018.255
G192.168.018.200
3
RMS ADV. & RMS LITE
1
Reset
Resets the RMS to a defined
standard state (> 5).
2LED
"Fault" (red) lights, up in connection
with reset,overload or a serious sys-
tem fault. "Warning" (yellow) lights
up if the conditions of an appropriately
configured filter apply (> 4.9), when
booting and in connection with Reset.
"Power" (green) lights up when the
device is supplied with voltage.
9
"COM" communication socket
for connection to a PC or
terminal (serial communication
cable included).
2
Never connect both COM interfaces at the same time!
In the initial state, various status messages are displayed cyclically in the
LCD display. Each message is displayed for approximately 2 seconds.
Device name
SNMP Information (> 4.5.1)
– Name (N)
– Location (L)
– Contact (C)
Network Information (> 4.5)
– IP Address (I)
– Netmask (N)
– Broadcast Address (B)
– Gateway Address (G)
4 5 6 7
8
RMS ADVANCED
3
Illuminated LCD display. Plain
text display of inputs, messages
and alarms.
4
Contrast controller for the LCD display
5
Left key
Page back in the menu, reduce
values
6
Right key
Page forward in the menu,
increase values
7
MENU key
Change to menu level
8
ENTER key
Menu selection of confirm
values
9
17
9
Advertisement
Table of Contents
