Operating Your Fan And Remote Control - HAMPTON BAY ALTURA 68-INCH CEILING FAN Use And Care Manual

Operating Your Fan and Remote Control

Operating the fan
NOTE: Do not wait for the fan to stop before pressing the reverse button.
The fan will not reverse direction if the fan is not moving.
Remote Control - Your fan is equipped with a remote control to operate
the speed and lights of your new ceiling fan.
Speed setting for warm or cool weather depends on factors such as
the room size, ceiling height, number of fans and so on.
Warm weather - (Forward) A downward airflow creates a cooling effect.
This allows you to set your air conditioner on a higher setting without
affecting your comfort.
Cool weather - (Reverse) An upward airflow moves warm air off of the
ceiling. This allows you to set your heating unit on a lower setting
without affecting your comfort.
Setting the code
NOTE: This remote is equipped with 16 code combinations. To prevent
possible interference from or to other remote units, such as garage
door openers, car alarms, or security systems, simply change the
combination code. The code switch marked ON/DIM is for dimming
control of the lights: Set the code switch to ON to allow for no dimming
of the lights such as for fluorescent bulbs. Set the code switch to DIM
to allow for dimming of the lights.
NOTE: If using a light kit, the light switch located on the light kit
should be at "ON" position before operating the remote control.
Setting the code on the remote control
□
Remove the battery cover by pressing firmly on the arrow
and sliding the cover off.
□
Slide the code switches to your choice of either up or down.
The factory setting is up.
□
Install a 12-V battery (included)
□
Replace the battery cover on the remote control.
ON DIP
ON DIM
1 2 3 4
12V 23A
12
ON
ON DIM
1 2 3 4