Pioneer CDX-M8317ZT X1H/UC Service Manual page 35

6.2.2 ADJUSTMENT OF ELEVATION WHEN THE CD CORE UNIT HAS BEEN REMOVED
FOR MAINTENANCE
- Adjustment When Error Code 60 is Displayed Because of Malfunctioning Elevation
•Note :
Unlike the conventional mechanisms, the new mechanism detects the height of the stage using slide-variable
resistance.
To absorb dislocation of the stage height caused by differences in the mechanism and the CD core unit,
adjustment must be made for each CD-mechanism module using a variable resistor.
Normally, readjustment is not needed, as this has been adjusted at the factory. However, adjustment of elevation
is required according to the procedure explained below if an elevation error has occurred or if the CD core unit
has been removed.
•Purpose :
To adjust and confirm whether or not elevation operates correctly.
•Adjustment Method :
•Measuring Equipment: Millivoltmeter
•Measuring Points :
•Setting : Without a magazine in Test mode
CD CORE UNIT
•Confirmation Procedure
1. Press key 10 enter Test mode, then select Multi-CD player.
2. Press key 3 to enter Mechanism Test mode.
3. Press key 8 twice to specify the amount of movement.
EREF, EPVO
With the mechanism placed upside-down (Place the CD mechanism module so that the
CD core unit is above.)
EREF
EPVO
The amount of movement
changes each time key 8 is
pressed.
maximum movement
Key 8
during movement
Key 8
Key 8
minimum movement
CDX-M8317ZT
mV meter
Examples of display
TRACK FUNCTION
' "
TRACK FUNCTION
72 00' 00"
TRACK FUNCTION
72 00' 02"
TRACK FUNCTION
72 00' 01"
TRACK FUNCTION
72 00' 00"
35