Panasonic NV-GS320 Operating Instructions Manual page 48

≥When no card is inserted in the movie camera,
the [PictBridge] indication does not appear.
(You cannot print any pictures.)
≥When the movie camera and the printer are not
connected properly, the [PictBridge] indication
keeps blinking. (It will blink for over
approx.1 minute.) Connect the cable or check
the printer.
≥When images are displayed in multi-screen,
they cannot be printed.
2
Select [SINGLE PRINT] or [DPOF PRINT].
≥If there is no file with a DPOF setting, you
cannot select [DPOF PRINT].
≥When you select [DPOF PRINT] for printing,
set the number of prints in DPOF setting.
≥When [DPOF PRINT] is selected, print after
you determine the paper size. (Step 6)
≥When [DPOF PRINT] is selected,date
printing is unavailable.
3
Move the joystick left and right to select a
desired picture, and then press it.
4
Select the desired number of prints.
≥You can set up to 9 prints.
5
Select the setting for date printing.
≥If the printer is not capable of date printing,
this setting is unavailable.
6
Select [PAPER SIZE].
[STANDARD]: Size specific to the printer
[4a5 INCH]
[5a7 INCH]
[4a6 INCH]
[A4]
≥You cannot set paper sizes not supported on
the printer.
7
Select [PAGE LAYOUT].
[STANDARD]: Layout set on the printer
[ ]
: No frame
[ ]
: With frame
≥You cannot set a layout not supported on the
printer.
8
Set [PRINT] >> [YES] to start printing.
48
VQT1A47
Edit mode
ª When you stop printing halfway
Move the joystick down.
≥Avoid the following operations during printing.
These operations disable proper printing.
≥Disconnecting the USB cable
≥Removing the card
≥Switching the mode dial
≥Turning off the power
≥Check the settings for the paper size, quality of
print, etc. on the printer.
≥Still pictures recorded on other equipment may
not be printed.
≥When the movie camera and the printer are
connected in the Tape Recording/Playback Mode,
the [ ] Indication may appear on the LCD
monitor. However, pictures cannot be printed.
≥The sides of pictures recorded when [16:9] is
set may be cut at printing. (When you purchase
this unit, [REC ASPECT] is set to [16:9].) When
using a printer with a trimming or borderless
function, cancel this setting. (Refer to the
operating instructions of the printer for details.)
≥Connect the printer directly to this unit. Do not
use a USB hub.