Page 1
VNG/VLP8-25021C/R VNG/VLP4-20021F VNG/VLP6-30021B VNG/VLP8-25021F VNG/VLP4-20021F/R VNG/VLP6-30021B/R VNG/VLP8-25021F/R ® LANDA, INC. 4275 NW Pacific Rim Blvd Camas, WA 98607 For technical assistance or the Landa Dealer nearest you, call 800-LANDA-4-U (800-526-3248) or (360) 833-9100 or consult our web page at www.landa-inc.com...
CONTENTS Introduction ..........................5 Important Safety Information ..................... 5 Installation ..........................5-11 Location ..........................6 Installation Guide ........................ 7 Gas Codes .......................... 8 Electrical ..........................8 Gas Piping .......................... 8 Propane Gas........................8 Natural Gas ......................... 9 Venting ..........................9 Draft Diverter ........................
Page 3
CONTENTS Burner Features ........................16 Operated Automatic Valve ....................16 Care of Main Burner ....................16-17 To Clean Burner Jets ......................17 VNG Control Panel ........................18 VNG Control Panel Parts List ....................19 VNG-L Exploded View, Left Side ....................20 VNG-L Exploded View, Right Side ...................
Install the machine 18” above the floor. supply of oxygen available for the amount of fuel be- 22. Landa will not be liable for any changes made to our ing burned. If it is necessary to install a unit in a poorly...
VNG/VLP SERIES PRESSURE WASHER OPERATOR’S MANUAL Gas Codes: Figure 2 Confer with local gas company and with proper municipal officials regarding any specific code or regulations gov- erning the installation. The installation must conform to manual local codes. shut off valve 1/8 in.
VNG/VLP SERIES PRESSURE WASHER OPERATOR’S MANUAL Natural Gas: When the pressure washer is installed in a tightly closed room without ventilation openings to the outdoors or other The following pipe sizes should be used between the meter rooms, provisions shall be made for supplying air for com- and the cleaner.
VNG/VLP SERIES PRESSURE WASHER OPERATOR’S MANUAL Inspection and Testing Gas Piping: WARNING & CHECK LIST The building structure should not be weakened by install- WARNING ing the gas piping. The piping should not be supported by 1. Installation or servicing of gas appliances and con- other piping, but should be firmly supported with gas hooks, trols must only be performed by qualified personnel.
Page 10
VNG/VLP SERIES PRESSURE WASHER OPERATOR’S MANUAL CHECK LIST BEFORE STARTING: Has gas supply been inspected by o l l , y l an authorized contractor to meet t l u local codes? i l f . e f a i l o i t Is unit protected from downdraft and g i l...
Secure nozzle by pushing the dry. coupler collar forward. The areas around the Landa washer should be kept clean 8. Turn the pump switch on and pull the trigger on the and free of combustible materials, gasoline and other flam- spray gun to activate the pressure switch which will mable vapors and liquids.
VNG/VLP SERIES PRESSURE WASHER OPERATOR’S MANUAL Pumps: MAINTENANCE AND SERVICE Use only SAE 30 weight non-detergent oil. Change oil af- Spray Nozzles ter first 50 hours of use. Thereafter, change oil every three Each unit is equipped with one or more spray nozzles, months or at 500 hour intervals.
In areas where alkaline water is an extreme prob- lem, periodic use of Landa Deliming Powder will remove BURNER FEATURES lime and other deposits before coil becomes plugged. (See Deliming Instructions for use of Landa Deliming Powder.)
VNG/VLP SERIES PRESSURE WASHER OPERATOR’S MANUAL Disconnect the pilot and ignition lines from the gas valve. Disconnect union in main burner line below ther- mostat. (Remove the nuts from the U-bolts, item 44 on page 20 on the VNG-S units.) Slide burner mani- fold out through shell opening.
VNG/VLP SERIES PRESSURE WASHER OPERATOR’S MANUAL VNG ELECTRICAL BOX All Models • PARTS LIST ITEM PART NO. DESCRIPTION ITEM PART NO. DESCRIPTION 90-1991 Screw 10/32" x 1/2" BIR 95-07163028 Box Elec VNG-L 6-0504 Block Terminal, 4 Pole 6-0517 Strain Relief, 3/4" 6-03680 Timer Solid State 120V 1 min 90-2018...
VNG/VLP SERIES PRESSURE WASHER OPERATOR’S MANUAL TROUBLESHOOTING BURNER PROBLEM POSSIBLE CAUSE SOLUTION A. No main power With power switch on, open trigger gun and set FLOW & BURNER your test meter to the 24 volt scale. Probe SWITCH ON. NO SPARK, terminals TH and TR.
Page 37
VNG/VLP SERIES PRESSURE WASHER OPERATOR’S MANUAL TROUBLESHOOTING Burner Continued y t l l i o t l o . e l y t l t i n s t i o l i t i n t i n . t i s t l s t l o l i...
Page 38
VNG/VLP SERIES PRESSURE WASHER OPERATOR’S MANUAL TROUBLESHOOTING y t l l l a c i f t l i f , d l h t i . e l t l e p i l . t l y t l l l a i l p t i k...
Page 39
VNG/VLP SERIES PRESSURE WASHER OPERATOR’S MANUAL TROUBLESHOOTING t i n i f i o i t n i l n i l i t c i f i o i t c i f e i l . P . o l f o i t n i l...
VNG/VLP SERIES PRESSURE WASHER OPERATOR’S MANUAL TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION FLUCTUATING Valves worn Check and replace if necessary. PRESSURE Blockage in valve Check and replace if necessary. Pump sucking air Check water supply and air seepage at joints in suction line.
VNG/VLP SERIES PRESSURE WASHER OPERATOR’S MANUAL BASIC FACTS BASED ON 60° f PROPANE BUTANE Formula C3H8 C4H10 Vaporization Point (°F) -43.7 31.1 Specific Gravity (Vapor) 1.522 2.006 Specific Gravity (Liquid) 0.508 0.584 Lbs. Per Gallon (Liquid) 4.23 4.87 B.T.U. Per Cubic Foot (Vapor) 2.563 3.39 B.T.U.
Attention to regular preventative maintenance procedures will assist in preserving the performance of your equipment. Contact your Landa dealer for maintenance. Regular preventative maintenance will add many hours to the life of your pressure washer. Perform maintenance more often under sever conditions.
If you are unable to resolve the warranty claim satisfactorily, write to LANDA at 4275 N.W. Pacific Rim Blvd., Camas, WA 98607, ATT: Warranty Dept., detailing the nature of the defect, the name of the Authorized LANDA Dealer, and a copy of the purchase invoice.
Page 45
® WATER CLEANING SYSTEMS 4275 N.W. Pacific Rim Blvd. • Camas, WA 98607 Form #96-610 • Revised 5/99 • Printed in U.S.A. for Landa, Inc., Camas, WA 98607...
Need help?
Do you have a question about the VNG/VLP3-11021D and is the answer not in the manual?
Questions and answers