Sound Adjustments; Attenuating The Input Signal; Turning Off The Subwoofer - JVC RX-5032VSL Instructions For Use Manual

Sound Adjustments

Front panel

Attenuating the Input Signal

When the input level of the analog source is too high, the
sound will be distorted. If this happens, you need to attenuate
the input signal level to prevent the distortion.
Once this has been adjusted, this receiver memorizes the
adjustment for each source.
Press and hold INPUT ATT on the front panel so that the
INPUT ATT indicator lights up on the display.
• Each time you press and hold the button, the Input
Attenuator mode turns on ("INPUT ATT ON") or off ("INPUT
NORMAL").
INPUT ATT
RX–5032V AUDIO/VIDEO CONTROL RECEIVER
DIGITAL AUTO SPK 1 2 ONE TOUCH OPERATION BASS BOOST INPUT ATT EON RDS SLEEP
ANALOG L C R PRO LOGIC DSP H.PHONE AUTO MUTING TUNED STEREO TA NEWS INFO VOLUME
LINEAR PCM S.WFR LFE
DIGITAL LS S RS
CH–
SUBWOOFER
OUT ON/OFF
Remote

Turning Off the Subwoofer

NOT
When the subwoofer is set to "YES" (see page 13), you can
choose to turn off subwoofer output.
Press SUBWOOFER OUT ON/OFF on the front panel to
turn off the subwoofer.
"SUBWOOFER OFF" appears on the display for a while and
the
S.WFR
The subwoofer sound comes out of the front speakers.
To turn on the subwoofer, press the button again.
Notes:
• This button does not work when the subwoofer is set to "NO" (see
page 13). In this case, "NO SUBWOOFER" will appear on the
display for a while.
• You cannot turn off subwoofer output when the front speaker size is
set to "SMALL."
• When you change the subwoofer setting from "NO" to "YES,"
subwoofer output is automatically turned on.
indicator goes off.
Remote
NOT
16