BCM BC945G User's Quick Start Card

Clear CMOS (JP1)
Clear CMOS
1
JP1
2
3
*Default
NVM Protect
Enable *
JP3
1
2
*Default
BIOS Write Protect
Boot Block
1
JP2
2
3
4
*Default
COM2/ COM1 Header (J31, J33) Front Audio Header (J6)
Signal Pin Pin Signal Signal
DCD 1 2 RxD MIC2-L
TxD 3 4 DTR MIC2-R
GND 5 6 DSR Line2-L
RTS 7 8 CTS Front-Sense
RI 9 10 Key Line2-R
Front USB1/ USB2 Header (J21, J23) Chassis Instruction (J20)
Signal Pin Pin Signal
Signal
VCC 1 2 VCC Chassis#
USB- 3 4 USB-
GND
USB+ 5 6 USB+
GND 7 8 GND
Front Panel Header (J34)
KEY 9 10 NC
CD-IN (J10)
HDLED +
HDLED -
Pin Signal
1 CD-L
2 CD GND
3 CD GND
4 CD-R
Normal *
1
2
3
Disable
1
2
All Un- Protect*
1
1
2
2
3
3
4
4
Pin Pin Signal
1 2 AGND
3 4 -ACZ_DET
5 6 MIC-JD
7 8 KEY
9 10 Line2-JD
Pin
1
2
Signal Pin Pin Signal
1 2 PWR LED G
3 4 PWR LED Y
GND 5 6 PWR SW
RST 7 8 GND
VCC 9 10 SMBDATA
IRRX 11 12 SMBCLK
GND 13 14 KEY
IRTX 15 16 NC
BC945G
Intel Core™ 2 Duo, Pentium
®
Celeron ® D, 90/65nm Process
775
With Socket
User's Quick Start Card
Version 1.02
Inspect the Package:
One BC945G Motherboard
One IDE Cable (80 Pins)
One Floppy Cable
Two SATA Cable
One Driver DVD
Two COM Port cables w/bracket
One Standard I/O Shield
One User's Quick Start Card
Responsibility:
This manual is provided "As-Is" with no warranties of any kind, expressed or implied, including, but not limited to the
implied warranties or conditions of this product's fitness for any particular purpose. In no event shall we be liable for any
loss of profits, loss of business, loss of data, interruption of business, or indirect, special, incidental, or consequential
damages of any kind, even the possibility of such damages arising from any defect or error in this manual or product. We
reserve the right to modify and update the user manual without prior notice.
Attention: CPU Socket Protector
Please read the user's manual carefully prior installing the CPU. Do not remove CPU socket protector if no CPU is in the
LGA775 socket. Place the CPU protector back to the socket during transport and when returning board for service.
http://www.intel.com/cd/channel/reseller/asmo-
na/eng/products/box_processors/desktop/proc_dsk_p4/technical_reference/99345.htm#processorinstallation
WARNING: CMOS Battery Damage
Replace your system's CMOS RAM battery only with the identical CR-2032 3V Lithium-Ion coin cell (or equivalent) battery
type to avoid risk of personal injury or physical damage to your equipment. Improper installation might cause battery to
explode. Always dispose of used batteries according to the MFR's instructions, or as required by the local ordinance
(where applicable). The damage due to not following this warning will void your motherboard's manufacturer warranty.
Perchlorate Material- Special Handling May Apply.
See http://www.dtsc.ca.gov/hazardouswaste/perchlorate/
Additional Information:
Additional information on setting this board up can be found in the User's Manual in the provided CD or DVD ROM. The
Online User's Manual and FAQ/Knowledge Base can be found on our website by visiting our website:
http://www.bcmcom.com. If your question is not answered in our FAQ/Knowledge Base, visit our forums and post your
messages or submit a new FAQ through FAQ Submittal form for us to add your question in our FAQ with our answer.
ATTENTION: Incorrect BIOS Setup
If you do not know how to handle BIOS setup or how to set it up properly, it is strongly advisable that you do not modify
any of the settings than otherwise instructed in the User's Quick Start Card. Even a seemingly small incorrect adjustment
or modification in the BIOS setup can render your system unstable or unusable. Incorrect BIOS setup is not covered by
your motherboard's manufacturer warranty. Try Clear CMOS information when system does not boot after BIOS settings
change.
D, Pentium 4, Pentium Dual-Core,
® ® ®
Processors Support
http://www.bcmcom.com
BC945G