Installing The Input/Output Panel; Removing The System Board - Dell OptiPlex 9010 Mini-Tower Owner's Manual

7. Slide the I/O panel towards the left of the computer to release it and pull the I/O panel along with its cable out of the
computer.

Installing the Input/Output Panel

1. Insert the I/O panel into the slot on the chassis front.
2. Slide the I/O panel towards the right of the computer to secure to the chassis.
3. Use a Phillips screwdriver to tighten the single screw securing the I/O panel to the chassis.
4. Thread the I/O panel and FlyWire cables into the chassis clip.
5. Connect the I/O panel and FlyWire cables to the system board.
6. Install the front panel.
7. Install the cover.
8. Follow the procedures in

Removing the System Board

1. Follow the procedures in
2. Remove the:
a) cover
After Working Inside Your Computer .
Before Working Inside Your Computer .
31