Operation; Outputs - MC2 Audio T2000 Operating Instructions Manual

OUTPUTS

The speaker outputs are via Neutrik Speakon connectors. 2 pole (NL2FC) or 4 pole (NL4FC) connectors can be used.
Terminations are as follows :- HOT
Additionally Channel A Speakon connector carries Channel B output on Pins +2 & -2 to allow easy bi-amping or
bridged operation.
(See also Bridged operation Page 7)
NOTE: 1. There must be no shared connections between channels.
NOTE: 2. Because the currents involved are very high, the speaker cables should conform to the following
minimum requirements, otherwise the losses will cause the cables to get hot and audio power will
be reduced:
T2000, 16A: T3500, 20A - into 4ohm speaker loads
NOTE: Do not connect the inputs/outputs to any other voltage source such as a battery, mains source or
power supply, regardless of whether the amplifier is turned on or off.
Do not run the output of any amplifier channel back into another channel's input and do not
parallel or series-connect an amplifier output with any other amplifier output.
BRIDGED (MONO) OPERATION
Supply the signal to Channel A input only & push in the rear panel switch marked 'Bridged Mono'
Use Channel A Output Speakon connector and connect as follows:
When operating in bridged mode, the minimum impedances are doubled. The minimum load in bridged
mode is: 8 ohms - T3500, 4 ohms - T2000.
LINK SOCKET
Each channel is provided with a 3-pin XLR connector marked 'LINK' which allows the input signal to be linked to
further amplifiers etc. The connections are the same as for the input XLR.

OPERATION

Read all documentation before operating your equipment and retain all documentation for future reference.
Do not spill water or other liquids into or on the unit and do not operate the unit while standing in liquid.
Do not block fan intake or rear ventilation outlets or operate the unit in an environment which could impede the free
flow of air around the unit.
If the unit is used in an extremely dusty or smoky environment, it should be cleaned of any collected debris at regular
intervals. (See Maintenance section.)
It is important that the power output of your amplifier is matched to the power handling capacity of your loudspeaker.
If not, damage to the loudspeaker could occur.
Pin
COLD Pin
HOT Pin
COLD Pin
HOT Pin +2
COLD Pin -1
+1
-1
+2
-2
10