MC2 Audio T2000 Operating Instructions Manual page 7

WARNING: Apparatus with CLASS I construction shall be connected to a MAINS socket outlet with a protective
earthing connection.
WARNING: To prevent injury, this apparatus must be securely attached to the rack in accordance with the installation
instructions.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings, install in
accordance with the manufacturer's instructions.
8. Do not install near any heat sources, such as radiators,
heat registers, stoves or other apparatus (including
amplifiers) that produce heat.
9. Protect the power cord from being walked on or
pinched particularly at plugs, convenience receptacles
and the pint where they exit from the apparatus.
10. The mains circuit breaker shall remain readily
accessible.
11. Only use attachments/accessories specified by the
manufacturer.
12. Use only with the cart, tripod, bracket or table
specified by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when
moving the cart/apparatus combination to avoid injury
from a tip over.
13. Disconnect this apparatus during lightning storms or
when unused for a long period of time.
14. Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as if the power-supply cord
or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate
normally, or has been dropped.
15. Do not expose this equipment to dripping or splashing
and ensure that no objects filled with liquids, such as
vases, are placed on the equipment.
16. To completely disconnect this equipment from the AC
mains, disconnect the power cord from the mains
circuit breaker.
17. Where the amplifier is mounted in a rack and
permanently connected to the mains, then the rack
should be installed with a readily accessible connector
or an ALL POLE circuit breaker with 3mm breaking
distances.
18. This unit is fitted with a 3-wire power cord. For safety
reasons, THE EARTH LEAD SHOULD NOT BE
DISCONNECTED IN ANY CIRCUMSTANCE.
19. The cooling fans suck cool air in through the front and
blow hot air out at the rear of the unit through the
ventilating grills. The front and rear of the amplifier
should have free exposure to the air (i.e. in a rack
leave the front and rear doors off), with 2cm air gap at
the sides and top. IF AIR IS NOT ALLOWED TO
ESCAPE FROM THE REAR, OVER-HEATING WILL
OCCUR. Take care when mounting other equipment in
the same rack.
20. The mains switch on the amplifiers only switches one
pole of the mains supply, therefore for units with a
detachable cord to be fully disconnected from the
mains, the mains disconnect device (ie mains plug or
mains coupler) should remain readily operable. For
units with a fixed mains lead the external all pole
circuit breaker with 3mm breaking distances is the
disconnect device and therefore the installation of the
amplifier shall be carried out in accordance with all the
applicable installation rules.
7