Lincoln Electric WIRE FEED MODULE IM 513-B Operator's Manual page 17

8. Feed power cable assembly through the rectangu-
lar window on the bottom of the generator.
9. Connect power cable/thermostat assembly and the
existing cables to the negative brushholder using
the .75" long 5/16" hex head cap screw, (provided
in the mounting hardware packet). Make certain
the thermostat assembly does not touch the brush-
holder spring and the cable is clear of any moving
parts. Make certain the thermostat is assembled
under the cable connections. (1/2" socket, ratchet,
small extension).
10. Reposition the brush wraparound cover and
tighten with the hardware removed in step 5.
Keep the tightening flanges below the 3:00
position. (Large flat head screwdriver and pliers.)
11 Locate and remove 12-pin jumper plug and install
12-pin connector from control box to 12-pin con-
nector. Connect control box 6-pin connector to
control panel 6-pin connector. Connect control
box 9-pin connector to control panel 9-pin connec-
tor.
12. Remove two (2) fuel tank hold down bolts on the
right side of the machine and save hardware.
13. Position control box into place. On some models,
the control box must be maneuvered out, up and
back to clear the door latch catch. On SAE-300 4
plastic fuel tank mounting bolts require loosening
to slide the tank towards the engine.
– 17 –