Maintenance And Service; Maintenance And Cleaning - Bosch GTA 3800 Professional Original Instructions Manual

Saw stand

Hide thumbs Also See for GTA 3800 Professional:

Original instructions manual (171 pages)

Operating/safety instructions manual (40 pages)

Original instructions manual (116 pages)

Table of Contents

OBJ_BUCH-1199-001.book Page 21 Thursday, April 8, 2010 1:35 PM

Transport Wheels and Stop for Swift Changing

of the Location (see figures I1 – I2)

The transport wheels 12 enable the saw stand

to be transported to a different location, with-

out having to remove the mounted stationary

saw.

The transport wheels 12 can be fastened either

to the left or right of the saw stand.

For assembly, use the fastening kit 20.

– Lay the saw stand upside down on the floor

(the folded-in legs facing upward).

– Screw the transport wheels at the desired lo-

cation to the saw table with the four screws

and nuts.

Use the provided Allen key 14 for this.

– Turn around the saw stand to the working

position.

– Loosen the locking knob 3 on the side of the

saw stand on which the transport wheels are

fastened and pull the table extension 2 light-

ly outward.

– Insert the transport stop 11 into the upper

groove of the saw stand and slide the trans-

port stop to the attachment set 4.

– Firmly tighten the hexagon bolt in the stop

with the provided socket spanner 14.

When transporting, the attachment set with

the mounted power tool can no longer slip

off.

Transport (see figure J)

The saw stand must be folded together for

transport.

– In case a support leg 13 is mounted, remove

it.

– Slide the table extensions 2 completely in-

ward.

– Tilt all legs inward (press locking pin 15 in-

ward; tilt each leg inward until the locking

pin can be heard to engage again).

– Grasp the recessed handle and lift up the

saw stand.

Bosch Power Tools