Operation - Bosch GTA 3800 Professional Original Instructions Manual

OBJ_BUCH-1199-001.book Page 20 Thursday, April 8, 2010 1:35 PM
20 | English
Fastening the Power Tool to the Attachment
Sets (see figure D)
– Position the power tool in the transport posi-
tion.
Notes on the transport position are given in
the operating instructions of the respective
power tool.
– Position the movable nuts 18 in the attach-
ment sets so that they match the mounting
holes of the power tool.
– Screw the attachment set and the power tool
with the hexagon bolts and the washers from
the fastening kit 19 using the provided sock-
et spanner 14.

Operation

Working Advice
Do not overload the saw stand. Always observe
the maximum carrying capacity of the saw stand
and the two table extensions.
Always hold the workpiece firmly, especially the
longer and more heavy section. After cutting
through the workpiece, the centre of gravity
may become dislocated in such an unfavourable
manner that the saw stand tips over.
Preparing the Workpiece Support
Long workpieces must be underlaid or support-
ed at their free end.
Adjusting the Height of the Workpiece Support
(see figure E)
– Place your workpiece onto the saw table of
the power tool.
– Loosen locking knob 5 and adjust the height
of the roller stand 7 so that the workpiece
rests level.
– Retighten the locking knobs again.
1 609 929 U17 | (4/8/10)
Sawing Workpieces of the Same Length
(see figure F)
The length stop 8 can be used for easily sawing
workpieces to the same length.
– Pull the length stop 8 upward until it engag-
es.
– Position the workpiece support 1 at the de-
sired clearance to the saw blade of the pow-
er tool.
– To slide in the length stop 8, tilt it inward and
push it all the way down.
Extending the Saw Stand (see figure G)
The saw stand can be extended on both sides.
To stabilise the saw stand when working long
and heavy workpieces, the table extension 2 can
be supported with a support leg 13.
(see "Support Leg for Supporting the Table Ex-
tension", page 20)
– Place your long workpiece onto the saw table
of the power tool.
– Release the respective locking knob 3 as re-
quired, and pull the table extension 2 out to
the desired position.
– Retighten the locking knobs again.
Fitting the Accessories
Support Leg for Supporting the Table Exten-
sion (see figure H)
To stabilise the saw stand when working long
and heavy workpieces, the table extension 2 can
be supported with a support leg 13.
The support leg 13 can be fastened either to the
left or right of the saw stand.
– Loosen locking knob 3 and pull the table ex-
tension 2 to be supported somewhat out-
ward.
– Slide the screw head of the support leg 13 in-
to the bottom groove of the table extension
2.
– Tighten the support leg 13.
– Screw the height adjustment of the support
leg 13 in or out until the saw table is aligned
level again.
Bosch Power Tools