Product Features - Klutch 3218 Owner's Manual

PRODUCT FEATURES

Note: For additional information regarding the parts listed in the following pages, refer to the
Assembly Diagrams on page 14.
CAUTION! Always make sure the power switch (66) of the Demolition Breaker is in its "OFF"
position and the tool is unplugged from its electrical outlet prior to adding accessories or performing
maintenance on the tool.
Oil Cap (45): Prior to the Demolition Breaker's first use, remove the oil cap and check to make
sure the tool is properly filled with grease. If necessary, fill the tool with approximately 1-1/4
ounces of #3 Lithium-based grease (not included). Then, replace the oil cap. Thereafter,
replace the grease at the end of every 70 to 80 hours of tool use. (See Figure E.)
Power Switch (66): The Demolition Breaker is switched "ON" by the slide switch located in the
rear Handle (62). To turn the tool "ON", slide the switch to the right. To turn the tool "OFF", slide
the switch to the left. (See Figure E.)
Variable Speed Control (72): The Demolition Breaker is equipped with a variable speed control
dial. The impact rate (BPM) and rotating speed (RPM) can be varied according to the type of
work being performed by setting the variable speed control dial to the selected setting:
1-2-3-4-5-6 ("1" being the lowest. "6" being the highest.) The variable speed control dial
may be adjusted while the motor is running with the tool free from work, allowing the operator to
adjust the impact rate and rotating speed according to the actual application. (See Figure E.)
Auxiliary Handle (104A) and Knob (105): The Demolition Breaker must be supported with the
auxiliary handle, which can be swiveled 360 degrees. To reposition and/or swivel the auxiliary
handle, loosen the knob. Move the auxiliary handle to the desired position along the barrel of
the tool and firmly retighten the knob. (See Figure E.)
Page of 16 9