Troubleshooting - Klutch 3218 Owner's Manual

TROUBLESHOOTING

Problem
Chisel installs with difficulty.
Tool does not run.
Tool does not stop.
Poor cutting efficiency.
Possible Solution
Make sure the Chisel shank, Front Cap, and
Slider are free of debris and lightly oiled or
greased. (See page 12.)
1. Make sure the Power Switch is in its "ON"
position. (See page 11.)
2. Make sure the Power Cord & Plug is
connected to a working 120 volt, grounded
electrical outlet. (See page 9.)
3. Make sure the Power Cord & Plug is not
damaged.
4. Make sure the tool is filled with approximately
1-1/4 ounce of #3 Lithium-base grease. (See
page 11.)
5. Check the Motor Carbon Brushes for
excessive wear and/or debris. Replace or
clean if necessary. (See page 14.)
6. Have a qualified service technician service the
tool.
1. Make sure the Power Switch is in its "OFF"
position. (See page 11.)
2. Immediately disconnect the Power Cord &
Plug from its electrical outlet, and have a
qualified service technician service the tool.
1. Make sure the Chisel is clean and sharp.
2. Adjust the Variable Speed Control Dial for the
type of work being done. (See page 12.)
3. Apply moderate pressure only. Allow the tool
to do the cutting without being forced.
4. Check the Motor Carbon Brushes for
excessive wear and/or debris. Replace or
clean if necessary. (See page 14.)
5. Have a qualified service technician service the
tool.
Page of 16 12