Toyota 2003 MATRIX User Manual page 24

carownersmanual.net
carownersmanual.net
SETTING THE SYSTEM
You can set the system as follows.
1. Remove
switch.
2. Have all passengers get out of the
vehicle.
3. Close all the side doors, back door and
glass hatch securely.
4. Lock all the side doors and back door
with the key or wireless remote control
transmitter. At this time, the TVIP indi-
cator light comes on.
The system will be set in 30 seconds.
When the system is set, the indicator
light will start to flash.
20
5. Make
flashes. Then you may leave the ve-
hicle.
Never leave anyone in the vehicle when
you set the system because unlocking
from the inside activates the alarm.
Activating the alarm
If the system detects a threat to the
vehicle, it sounds the alarm for one
minute while flashing headlights and
turn signal lights. Also, the interior
lights turn on when the interior light
dial is in the DOOR position.
The system detects a threat under any of
the following conditions:
D
Either of the front doors is unlocked by
the key from the ignition
means other than the key or wireless
remote control transmitter.
If the key is not in the ignition switch,
all the side doors and back door will
be automatically locked again.
D
Any of the side doors, back door or
glass hatch are forcibly opened.
The alarm will activate when the back
door is unlocked with a key. Cancel the
system before unlocking the back door.
2003 MY COROLLA MATRIX_U (OM12767U)
'03 MATRIX_U (L/O 0201)
D
sure that the indicator light
D
D
After one minute, the alarm automatically
stops and the indicator light starts flashing
again.
Reactivating the alarm
Once set, until you cancel the system, the
system automatically resets the alarm af-
ter the alarm has stopped.
The alarm will activate again under the
same circumstances described in "Activat-
ing the alarm".
Stopping the alarm
You can stop the alarm in either of the
following ways:
D
D
The side windows are tapped or bro-
ken.
The battery terminal is disconnected
and then reconnected.
The ignition is hotwired.
Unlock any of the side doors with the
key or wireless remote control transmit-
ter.
Place the ignition switch in the "ON"
position.