Toyota 2003 MATRIX User Manual page 115

carownersmanual.net
carownersmanual.net
Alternate Frequency
To turn the AF mode on, push and hold
the "AM/FM" button until you hear a beep.
"AF ON" will appear on the display.
When reception condition worsen, the au-
dio system will select the RDS station
which has the same PI (Program Identifi-
cation) code.
To turn the AF mode off, push and hold
the "AM/FM" button again until you hear
a beep. "AF OFF" will appear on the dis-
play.
BAL/FADE (Sound balance adjustment
function)
This button is used to adjust the sound
balance between the front and rear, and
the right and left speakers.
For front/rear adjustment, push the "BAL/
FADE" button repeatedly until "FAD" ap-
pears
"TUNE/SELECT" knob to adjust the front/
rear balance.
For left/right adjustment, push the "BAL/
FADE" button repeatedly until "BAL" ap-
pears
"TUNE/SELECT" knob to adjust the left/
right balance.
on the display. Then turn the
on the display. Then turn the
'03 MATRIX_U (L/O 0201)
To return to the middle position balances,
push and hold the "BAL/FADE" button for
two seconds.
CD/AUX (Compact Disc/Auxiliary)
Push the "CD/AUX" button to switch from
radio to compact disc operation. A disc
must already be loaded in the player.
Error codes
If the player malfunctions, your audio sys-
tem will display the following error mes-
sages.
"CHECK CD":
D
The road is too rough. The disc should
play when the road is smoother.
D
The disc is dirty, scratched, wet or
upside down.
D
The air is very humid. If so, wait about
an hour and try again.
If the disc is not playing correctly, for any
other reason, try a known good compact
disc.
"PLAYER ERROR": There is trouble in-
side the system. Eject the disc. Set the
disc again.
If malfunction is not rectified, take your
vehicle to your Toyota dealer.
2003 MY COROLLA MATRIX_U (OM12767U)
EQ (Equalizer)
Your audio system can store five different
EQ settings so that you will not need to
readjust it every time you listen to a dif-
ferent program.
To use a preset setting:
Push the "EQ" button repeatedly until the
EQ number you want to use appears on
the display.
To change a preset EQ setting:
1. Use the "TONE" button and
"TUNE/SELECT" knob to select
desired equalization. (For details, see
"TONE".)
2. Push and hold the "EQ" button until
"SELECT EQ #" appears on the dis-
play.
3. Push the "EQ" button repeatedly or
turn the "TUNE/SELECT" knob to select
the desired preset EQ number.
4. Push and hold the "EQ" button until
"EQ SAVED" appears on the display
and you hear a beep. This EQ setting
is saved to that number.
HR/MIN (Hours/minutes adjustment)
These buttons are used to adjust the
clock time. (For details, see "Clock" on
page 150 in Section 1−9.)
the
the
111