Control Panel; Navigation; Dmx Address And Protocol Setting - Martin Professional MAC 2000 Profile User Manual

C
ONTROL PANEL
The LED control panel is used to set the address and personalities, read lamp hours and other information, calibrate
effects, and run a test routine. Most of these functions may be performed remotely via the serial link with the Martin
MP-2 Uploader.

Navigation

The DMX address and any messages (see page 34) are displayed when the MAC 2000 Profile is turned on. To enter the
menu, press [Menu]. Press [Up] and [Down] to move within the menu. To select a function or submenu, press [Enter].
To escape a function or menu, press [Menu].
Note: [Enter] must be pressed and held for a few seconds to enter the utilities menu.
See Table 6 on page 28 for a complete list of the menu items.
AddR PSET

DMX address and protocol setting

The DMX address, also known as the start channel, is the first channel used to receive instructions from the controller.
For independent control, each fixture must be assigned its own control channels. Two MAC 2000 Profiles may share
the same address, however, if identical behavior is desired. Address sharing can be useful for diagnostic purposes and
symmetric control, particularly when combined with the inverse pan and tilt options.
Two DMX protocols, 8-bit and 16-bit, are available. The 8-bit mode uses 20 control channels and provides full basic
control. The 16-bit mode uses 4 additional channels to provide finer gobo and pan/tilt positioning.
To set the DMX address and protocol
1 Press [Menu] to enter the main menu.
2 Press [Up] until
the desired channel and press [Enter].
3 Select
PS ET
PATI PTSP PERS PERS
STUd
SWAP NORM dISP dISP
PINV FAST dINT dINT
TINV SLOW dLOF dLOF
dRES dRES
ALON ALON
SCUT SCUT
TRAC TRAC
MOdE MOdE
CAL CAL
Figure 13: MAC 2000 Profile menu
is displayed. Press [Enter]. To snap to channel 1, press [Enter] and [Up]. Scroll to
A dd R
from the main menu and press [Enter]. Select

Control panel

Address/
Messages
dFSE dFSE INFO INFO dMXL dMXL
FACT FACT TIME TIME STCO STCO
RST
HRS HRS
CUS1 CUS1 dIM dIM
L ON
L HR L HR
L ST L ST
CUS2 CUS2 .... ....
LoFF
CUS3 CUS3 TEMP TEMP E SP E SP SHUT
dIM
bASE bASE
HEAd HEAd
CYAN
VER VER MAG
YEL
CTC
COL
gOb1
or
8b i t 16 bt
MAN TSEQ TSEQ UTIL UTIL
FEbA FEbA
I/S1
EFFb EFFb
gOb2
Adj
I/S2
RST
EFF
L ON
LoFF
I/SE
HEAd
PATI
IRIS
FOC CAL
ZOOM
dFOF
PAN
PCbT
TILT
UPLd
and press [Enter].
SMSG
13