Readouts; Service Messages; Service Utilities - Martin Professional MAC 2000 Profile User Manual

Readouts

Note: The MP-2 Uploader provides commands to display the time, temperature, and version readouts on the fixture
control panel.
T I M E
IN FO / TI M E
each item is a resettable (
since fabrication (
be done remotely using the MP-2 Uploader.)
T E M P E R A T U R E
IN FO / TE M P
F I R M W A R E V E R S I O N
IN FO / VE R
startup.
D M X
The D MX L

Service messages

The Service LED on the control panel lights under conditions that require fixture service, and there is a message
describing the service required. To display the message, select
when the LED is lit. There are two service messages.
Re p l ac e l a mp
HMI 1200 W/S lamp. The maximum service life is 125% of the average life, or 940 hours.
Fi xt u re o v er h ea ti n g
likely due to dirty air filters, fans, or air vents; incorrect power supply settings, or a defective fan.

Service utilities

Important! Enter must be held for several seconds to access the utilities menu.
T E S T S E Q U E N C E S
T S E Q provides a general test of all effects that can be run without a controller.
for circuit board testing that are for service use only.
F E E D B A C K T O G G L E S
An on-the-fly position correction system monitors the color wheel, gobo wheels, gobos, rotating effects, and effect
wheel. If a position error is detected, the shutter closes while the effect resets. This feature can be disabled by turning
effects feedback (
The automatic pan/tilt position correction system may be temporarily turned off under
setting, however, is not saved and the system will be re-enabled the next time the fixture starts. If the system cannot
correct the pan/tilt position within 10 seconds, feedback is automatically disabled.
A D J U S T M E N T
The adjustment menu (
provides readouts of fixture hours (
R S E T ) increment counter and a non-resettable counter for total accumulated hours/strikes
T O TL ). To reset an increment counter, display it and then press [Up] until it reads 0. (This may also
provides readouts of the head and base temperature in Celsius and Fahrenheit.
displays the version number of the installed firmware. The firmware version is also displayed briefly at
menu shows the DMX start code (
is displayed when the lamp counter exceeds 750 hours, which is the rated average life for the
is displayed when the head temperature exceeds 120° C (248° F). Overheating is
U T IL / EF Fb ) off.
U TI L /A dj ) provides manual control for making mechanical adjustments. See page 33.
H RS
), lamp hours (
S T CO ) and DMX values received for each effect.
S M S G
Control panel
L HR
), and lamp strikes (
in the main menu. This item is available only
U T I L / P C B t
U T I L / F E b A
L ST
). Under
provides routines
. The off
15