Wall Mounting; Floor Mounting - Norseman XB1 Installation, Operation & Maintenance Instructions Manual

5.0

WALL MOUNTING

5.1 Install heater with the supplied hardware in
accordance with the Figures and instructions
below.
Step 1: Secure wall and stabilizing brackets to
mounting surface (Figure 3).
FIGURE 3 - INSTALL MOUNTING BRACKET
Step 2: Position heater face down on floor
with terminal box towards mounting brackets.
(Ensure that baffles are installed [see section
3.6 of this manual]). Angle heater such that the
terminal box rests on bottom of wall bracket.
Lift top of heater and align with top stabilizing
brackets.
Secure with supplied 1/4"-20 hex bolts and
lock washers (Figure 4).
FIGURE 4 - WALL MOUNTING DIAGRAM
Step 3: Secure bottom of heater to wall
mounting brackets with supplied 1/4"-20 hex
bolts and lock washers (Figure 5).
FIGURE 5 - ATTACH HEATER TO MOUNTING BRACKETS
6.0

FLOOR MOUNTING

Step 1: Position heater face down on the floor
with terminal box towards the wall (Figure 6).
FIGURE 6 - FLOOR MOUNTING DIAGRAM
Step 2: Fasten top stabilizing bracket(s) and
floor mounting bracket(s) to the unit. Floor
mounting brackets may be mounted in one of
three orientations (Figure 7).
FIGURE 7 - INSTALL MOUNTING BRACKET TO HEATER
Step 3: Lift top of unit and position heater
vertically against the wall. Secure stabilizing
and floor mounting brackets to the mounting
surfaces (Figure 8).
FIGURE 8 - ATTACH HEATER TO FLOOR AND WALL
NEVER INSTALL ONE HEATER ABOVE
THE OTHER.
TO ENSURE SAFE OPERATION, HEATER
MUST BE INSTALLED, AS SHOWN IN FIGURES
5 & 8. INSTALLATION WITH FINS IN THE
CAUTION
INCORRECT ORIENTATION MAY RESULT IN AN
UNSAFE CONDITION (REFER TO TABLE 1).
3