Wall Mounting; Floor Mounting - Norseman XB Series Installation, Operation & Maintenance Instructions Manual

C.3

Wall Mounting

Install heater with the supplied hardware in accordance with the
figures and instructions below.
Step 1: Secure wall and stabilizing brackets to mounting surface
(Figure 3).
Figure 3 – Install mounting bracket
Step 2: Position heater face down on floor with terminal box
towards mounting brackets. (Ensure that baffles are
installed [see Section C.2, page 4]). Angle heater such
that the terminal box rests on bottom of wall bracket. Lift
top of heater and align with top stabilizing brackets.
Secure with supplied 1/4"-20 hex bolts and lock washers
(Figure 4).
Figure 4 – Wall mounting diagram
Step 3: Secure bottom of heater to wall mounting brackets with
supplied 1/4"-20 hex bolts and lock washers (Figure 5).
Figure 5 – Attach heater to mounting brackets
WARNING. Improper orientation of the heater could
affect the safe and reliable operation of the heater.
WARNING
6
C.4

Floor Mounting

Step 1: Position heater face down on the floor with terminal box
towards the wall (Figure 6).
Figure 6 – Floor mounting diagram
Step 2: Fasten top stabilizing bracket(s) and floor mounting
bracket(s) to the unit. Floor mounting brackets may be
mounted in one of three orientations (Figure 7).
Figure 7 – Install mounting bracket to heater
Step 3: Lift top of unit and position heater vertically against the
wall. Secure stabilizing and floor mounting brackets to the
mounting surfaces (Figure 8).
Figure 8 – Attach heater to floor and wall
WARNING. Never install one heater above the other.
To ensure safe operation, heater must be installed, as
WARNING
shown in Figure 5 and Figure 8. Installation with fins
in the incorrect orientation may result in an unsafe
condition (refer to Table 1, page 4).