Select Suitable Location; Output Connections; Work Clamp Installation - Lincoln Electric PRO-MIG 175 IM810 Operator's Manual

A-3

SELECT SUITABLE LOCATION

Locate the welder in a dry location where there is free
circulation of clean air into the louvers in the back and
out the front of the unit. A location that minimizes the
amount of smoke and dirt drawn into the rear louvers
reduces the chance of dirt accumulation that can block
air passages and cause overheating.
STACKING
Pro-MIG 175's cannot be stacked.
TILTING
Each machine must be placed on a secure, level sur-
face, either directly or on the recommended cart. The
machine may topple over if this procedure is not fol-
lowed.

OUTPUT CONNECTIONS

Refer to Figure A.2.
1. Work Cable Access Hole.
2. Gun Cable and Control Lead Access Hole.
3. Connector Block.
4. Gun Trigger Lead Connectors.
5. Positive (+) and negative (–) output terminals.
Pro-MIG" 175
INSTALLATION
FIGURE A.2
5
DO NOT SWITCH
WHEN WELDING
8
1
2
Pro-MIG 175
6. Wire Feed Gearbox.
7. Cable Hanger.
8. Thumbscrew.
Refer to the Accessories Section for available optional
equipment.

Work Clamp Installation

Attach the work clamp per the following: Refer to
Figure A-3.
FIGURE A.3
1. Insert the work cable terminal lug with the larger
hole through the strain relief hole in the work clamp
as shown above.
2. Fasten securely with the bolt and nut provided.
4
+
-
3 6
7
A-3