Trim Rod End Cap Seal; Trim Rod Installation - Mariner 70 Service Manual

1. Inspect check valve and check valve screen for
debris; if debris cannot be removed, replace trim
rod assembly. Clean trim rod with parts cleaner
and dry with compressed air.
a - Check Valve
b - Check Valve Screen
90-13645--2 495

Trim Rod End Cap Seal

1. Inspect trim cap end seal and replace if damaged
or if seal does not keep trim rod clean.
a - Seal (Remove as shown)
2. Install new seal with seal lip up.

TRIM ROD INSTALLATION

a
IMPORTANT: Components must be free of dirt and
lint. Any debris in the system can cause system
to malfunction.
NOTE : Install trim rod with check valve in the port (left)
b
cylinder.
51352
1. Apply Quicksilver Power Trim and Steering Fluid
on all O-rings and seals before installation.
2. Install trim rods and caps. Use installation tool
(91-44487A1) or spanner wrench (91-74951) to
tighten caps securely.
a - Trim Rods
b - Cylinder End Caps
c - Rod End Rollers (Lubricate with Quicksilver Anti-Corrosion
Grease or 2-4-C w/Teflon)
POWER TRIM
a
c a c a
b
51343
51353
6B-21