Screen Security - Honeywell Tuxedo Touch Series Installation And Setup Manual

Safe Mode
The Safe Mode may be automatically entered by the program on a communication failure or may be
entered manually on command.
Automatic Entry
In the rare event that the keypad cannot successfully communicate in its graphic mode with the control
panel, the screen presents you with a message of "Problems detected. Start Keypad in Safe Mode?" and
requests a "Yes" or "No" response. If you answer with "Yes", the keypad goes into the Safe Mode. If you
answer with "No", the keypad tries to communicate with the panel again. After 3 consecutive times of
receiving no response, the keypad enters the Safe Mode automatically.
Manual Entry
Note: ONLY enter the Safe Mode from the Normal Mode. Entering the Safe Mode from the Automation
and Demo Mode may result in incorrect display of the Emergency Function keys.
ICON
1. Select Safe Mode and then press Apply.
! SAFE MODE !
2. Press OK. To exit, touch the safe mode bar
and touch Yes to return to Normal Mode.
Operating in the Safe Mode
While in the Safe Mode, the Home screen displays the Security Icon, Panic Icon, and Message Icon. A
message at the lower left side of the screen is displaying: !SAFE MODE!
This is a limited mode of operation. While in this mode:
• You can use the Security icon to access the Console Emulation Mode of operation to try to clear your
faults, disarm the system, or enter additional Alpha Keypad commands specified in your panel User
and Installation Guides. You can perform almost all functions that you can perform from a standard
non-graphic alpha keypad.
• You can press the "Panic" icon and generate Emergency Messages as defined in the panel's home
partition for this keypad.
• The Armed and Ready LEDs on the front of the keypad indicates the keypad's home partition status.
• The Chime mode functions in the Safe Mode: however, you do not have Voice, Voice Chime, or
Message capability.
• Z-Wave Scenes do not function in Safe Mode.
• The Slide Show feature does not start automatically in Safe Mode.

Screen Security

The Screen Security icon displays a list of authority levels and the user level that has been given
access to them. To view and/or edit Screen Security, do the following:
ICON
1. From the System Setup screen, press the
CS Setup icon.
2. Enter your Authorized Code.
3. Press the Screen Security icon.
4. If authority levels are correct, press
System Setup (cont'd)
ACTION
ACTION
18
NOTES
The "Warning" message "Keypad will reset to
activate changes" is displayed.
The keypad resets and restarts in the Safe Mode.
NOTES
Note: The Screen Security screen contains a
heading of Advanced Setup, Central Station Setup,
Disp. & Audio Setup, Event Logs, Lighting,
Message, Security, or Time/Date highlighting the
line was selected for change.
The Screen Security screen is re-displayed listing