Operating Steps; Welding In Tig Mode - Lincoln Electric PRECISION TIG SVM186-A Service Manual

B-7

OPERATING STEPS

WELDING IN TIG MODE

1. Connect the TIG torch and cable Twist-Mate™ quick
connect plug to the Electrode/Gas output recepta-
cle. This receptacle also contains an integral gas
connection for the torch. Connect the work clamp to
the work piece.
2. Set the TIG/STICK switch to "TIG".
3. Set the Polarity Switch to DC- for welding steel or
stainless steel; or to AC for welding aluminum.
4. Connect the Foot Amptrol to the Remote Control
Connector.
5. Turn on the cylinder gas valve and adjust the flow
regulator to obtain desired flow.
6. Turn the power switch to "ON". NOTE: There will be
a 15 second gas flow when the power is turned on.
7. Preset the Output Control on the control panel to the
maximum desired amps, as read on the digital
meter.
8. Depress the Foot Amptrol to energize the torch and
establish an an arc with the work piece. The digital
meter reads the actual amps while welding.
NOTE: When the TIG/STICK switch is set to "TIG",
depressing the remote control will start a 0.5
second gas pre-flow before energizing the TIG
torch. When the remote control is released the
TIG torch is de-energized and gas flow will con-
tinue for the time set by the Post Flow Time
control. When the polarity switch is set to DC,
the TIG Arc Starter will turn on and off auto-
matically to start and stabilize the arc. In AC the
TIG Arc Starter will turn on with the output and
remain on continuously until the remote control
is released.
PULSE TIG CONTROL
Use this knob to set the frequency or the number of
pulses per second(pps), from 0.1pps to 20pps.
• This setting adjusts heat output and bead shape for
travel speed. Thinner plate that is welded with faster
travel speed will require higher frequency than thick-
er plate with slower travel speed. 2-3pps is a typical
starting point.
OPERATION
PRECISION TIG® 225
B-7