Sea-doo GTI California 6116 Shop Manual page 110

Remove the compression spring no. 19.
1. Remove spring
Unscrew valve piston no. 20 from sliding valve
no. 22.
NOTE: Hold the sliding valve to prevent it from
turning.
1. Unscrew piston
2. Hold sliding valve
SMR2002-024_04_05A.FM
Remove sliding valve from valve housing.
1. Valve piston
2. Valve housing
3. Sliding valve
Cylinder Head Cover and Cylinder Head
Disconnect temperature sensor wire and spark
plug cables.
Connect spark plug cables on grounding device.
717 Engine
Remove air intake silencer and support, refer to
AIR INTAKE.
717 and 787 RFI Engines
Remove screws no. 14.
Remove cylinder head cover no. 1.
If shells, sand, salt or any other particles are present
in cylinder head, clean with a vacuum cleaner.
Remove cylinder head no. 2.
If shells, sand, salt water or any other particles are
present in cylinder cooling jacket, clean with a vac-
uum cleaner.
947 Engines
Disconnect hose of RAVE valves.
On DI engines, remove air/fuel rail. Refer to EN-
GINE MANAGEMENT.
www.SeaDooManuals.net
Section 04 ENGINE
Subsection 05 (TOP END)
04-05-11