Installing The Camera; Installation; Function Settings - Siemens CCWC1335-LP Instruction Manual

Installing the Camera

7 Installing the Camera
7.1

Installation

7.2

Function Settings

14
Siemens Building Technologies
Fire Safety & Security Products
1. Connect the BNC cable to the video output ⑥
2. Connect the power source to the power terminal
Caution:
If using a DC supply, make sure the polarity is correct. Incorrect connection may cause malfunction
and/or damage to the camera.
3. To reduce radiation sufficiently, please wind one turn around the core, see figure
below.
Location
Power cable
Y/C cable
4. Adjust the backfocus
For backfocus adjustment, please loosen screw ②, set the camera to AES mode
(see section 7.2.16.2: BACK FOCUS), then the rotate backfocus wheel ① until a
sharp image appears. Tighten screw ②.
Select ENTER on the OSD; the menu will appear on the display and will disappear
after 30 seconds if no action occurs. The shaded setting area means an item is
selected and it keeps blinking.
Core illustration for what camera
LP
LP / MP
EIM-0050751G
03.2005