Protocol; Siemens Building Technologies - Siemens CCWC1335-LP Instruction Manual

Installing the Camera

7.2.17.4 PROTOCOL

7.2.17.5 SOFT VER
7.2.17.6 PATTERN
7.2.18 NEXT/ BACK
7.2.19 EXIT
7.2.20 CANCEL
7.2.21 DEFAULT
26

Siemens Building Technologies

Fire Safety & Security Products
Select one of the 3 various protocols, depending on the type of remote
connectivity, for remote OSD control camera setup:
SIEMENS-B: When using the camera with bi-directional remote control under
remote software and PC (remote software provides full parameter setup).
SIEMENS-U: When using the camera for unidirectional communication with
SIMATRIX via converter CAC0103 (V1.6).
SIEMENS-S: When using the camera in unidirectional communication with
SIMATRIX NEO based on the SCU protocol.
SOFT VER. indicates the current firmware version on the camera and may vary.
When the PATTERN is set to ON, there will be a horizontal color bar picture (as
shown below) on the display. The color bar is not standardized and might vary
between camera types.
Navigates to the next or previous screen display.
Saves all settings and exits.
Discards changes and leaves the settings as they were.
This function restores the factory settings.
03.2005