Switching Between Sxs Memory Cards; Formatting An Sxs Memory Card; Checking The Remaining Time Available For Recording - Sony PMW-EX3 Operating Instructions Manual

destroyed. Be sure that the ACCESS lamps are
lit in green or off when you turn off the power
or remove memory cards.
• When you turn the camcorder on by setting the
power switch to MEDIA (Media mode), a
display to show that an SxS memory card is
being confirmed appears in the viewfinder.
The display automatically changes to the
thumbnail screen (page 93) when a valid
memory card is inside, but it remains on the
screen if no valid memory card is loaded.
Switching Between SxS Memory
Cards
When SxS memory cards are loaded in both card
slots A and B, press the SLOT SELECT button to
select the card you wish to use.
If a card becomes full during recording, switching
to the other card is automatically executed.
Note
The SLOT SELECT button is disabled while
playback is in progress. Switching is not executed
even if you press the button. The button is enabled
on the thumbnail screen (page 93).

Formatting an SxS Memory Card

Formatting may be required before using an SxS
memory card with this camcorder. For an SxS
memory card that is not formatted or that was
formatted with another system, a message to
confirm if formatting is to be executed is
displayed in the viewfinder.
Note on formatting
Any SxS memory card formatted with a device
other than this camcorder cannot be used with the
camcorder.
To execute formatting
If the message for formatting is displayed,
turn the jog dial or tilt the joystick to select
"Execute" then press the dial or joystick.
Formatting begins.
The in-progress message and status bar (%) are
displayed, and the ACCESS lamp lights in red.
When formatting is completed, the completion
message is displayed for three seconds.
Recording/playback during formatting
You can perform recording or playback using the
SxS memory card in the other card slot while
formatting is in progress.
If formatting fails
A write-protected SxS memory card or memory
card that cannot be used with this camcorder will
not be formatted.
As a warning message is displayed, replace the
card with an appropriate SxS memory card, as per
the instructions in the message.
To format by menu operation
When no formatting message is displayed in the
viewfinder, you can execute formatting using
"Format Media" (page 127) of the OTHERS
menu in the same manner.
Notes
• All the data, including recorded pictures and
setup files, are erased when a memory card is
formatted.
• SxS memory cards to be used with this
camcorder must be formatted using the format
function of this camcorder. Any card formatted
with other device must be formatted again with
this camcorder.
Checking the Remaining Time
Available for Recording
In Camera mode, you can check the time
remaining for the SxS memory cards loaded in the
card slots in the viewfinder.
120min STBY
A: 25min
B: 50min
Z99
The available time for recording with the current
video format (recording bit rate) is calculated
according to the remaining space of each card and
displayed in time units of minutes.
The remaining can also be checked in a meter
format on the BATTERY/MEDIA status screen
(page 108).
Handling SxS Memory Cards
STBY T
43