Anti-Scalp Rollers - Land Pride ZT60 Operator's Manual

Section 3: Adjustments

Anti-Scalp Rollers

Refer to Figure 3-18:
Anti-scalp rollers are standard on the Accu-Z. These
anti-scalp rollers are designed to minimize scalping
when mowing on rough uneven terrain.
Adjusting
Holes
Anti-Scalp Rollers
Anti-Scalp Roller Adjustment
Figure 3-18
After setting the cutting height, adjust the front anti-scalp
rollers so they extend below the deck but do not contact
the ground. They should always be at least 1/4" to 3/4"
below the deck. With the unit sitting on a flat level
surface, the front wheel position can be adjusted up or
down as needed from 3/4" to 1 3/4" below the blade
surface. Move the front wheels up or down, in 1/2"
increments, using the different axle mount holes in the
roller mount bracket.
NOTE: When the anti-scalp rollers are installed, the
minimum cutting height is 1 1/2" with the anti-scalp
rollers set at 3/4".
9/03/10
Table of Contents
Front Axle Pivot
Refer to Figure 3-19:
The front wheels can be set to pivot about the center of
the mower frame to allow the front wheels to float with the
contour of the ground or locked to prevent the wheels
from floating.
23946
26689
Pivot set to float
1. Remove hairpin cotters (#1).
2. Pull axle pivot pins (#2) out approximately 1" until
2nd hole in pivot pins aligns with the hairpin cotter
holes.
3. Replace hairpin cotters (#1).
Pivot set not to float
1. Remove hairpin cotters (#1).
2. Push axle pivot pins (#2) in approximately 1" until 1st
hole in pivot pins aligns with the hairpin cotter holes.
3. Replace hairpin cotters (#1).
ZT60 & ZT72 Accu-Z
Pivot Locking Device
Figure 3-19
®
Zero Turn Mowers 357-103M 31