Anti-Scalp Rollers - Land Pride Accuz Z52 , Z60, Z72 Operator's Manual

Land Pride
Section 3 Adjustments

Anti-Scalp Rollers

Anti-scalp rollers are standard on the Accu Z. These anti-
scalp rollers are designed to minimize scalping when
mowing on rough uneven terrain.
After setting the cutting height, adjust the front anti-scalp
rollers so they extend below the deck but do not contact
the ground. They should always be at least 1/4" to 3/4"
below the deck. With the unit sitting on a flat level surface,
the front wheel position can be adjusted up or down as
needed from 3/4" to 1 3/4" below the blade surface. Move
the front wheels up or down, in 1/2" increments, using the
different axle mount holes in the roller mount bracket.
See Figure Figure 3-22.
Anti-Scalp Roller Adjustment
Figure 3-22
03/11/03
Anti-Scalp Rollers
Adjusting
Holes
19096
Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M
When adjusting the rear anti-scalp rollers, the roller should
be in the lower axle mount hole when the front anti-scalp
rollers are in the lower or middle axle mount holes. When
the front rollers are in the upper axle mount hole, the rear
rollers should be in the upper axle mount hole as well.
NOTE: When the anti-scalp rollers are installed, the
minimum cutting height is 1" with the anti-scalp
rollers set at 3/4".
29