Moving Mower With Stalled Engine - Land Pride ZT60 Operator's Manual

Section 2: Operating Procedures

Moving mower with Stalled Engine

Refer to Figure 2-8:
Located under the seat are two hydro-drives. One on the
right side and one on the left side. Each hydro-drive is
equipped with a bypass valve for moving the mower
manually when the engine is inoperable. The bypass
valve is located to the inside near the top and is identified
as a hex stud. Before moving mower manually:
1. Loosen hex jam nuts with 17mm wrench and turn both
bypass valves with 8mm wrench counter clockwise
one-half of a turn.
2. If the mower has electrical power, turn ignition switch
to (ON) and position both control levers in neutral with
handles together to release park brakes.
Refer to Figure 2-9:
3. If mower has lost electrical power, manually release
park brakes with release levers located at the rear
under the gas tanks. Raise levers and position them
into the notched slots. A pry bar leveraged over the
tires may be required to overcome the spring forces
required to set the park brakes.
IMPORTANT: Do not tow the machine. Move it by
hand or use a winch and load it on a trailer.
.
IMPORTANT: Following repairs and before
operating the mower, always make certain the two
bypass valves and two park brake release levers are
returned to their normal operating positions.
®
18 ZT60 & ZT72 Accu-Z Zero Turn Mowers 357-103M
Table of Contents
Front of Mower Faces This Direction
Figure 2-7
Bypass Valve
Hex Jam Nut
(17mm Wrench)
Bypass Valve
(8mm Wrench)
Bypass Valve (Left Side Shown)
Figure 2-8
Park Brake Release Lever (Right Side Shown)
Figure 2-9
23923
Hydro-Drive
23993
23932
9/03/10