Storage - Land Pride ZT60 Operator's Manual

Section 5: Maintenance & Lubrication
Refer to Figure 4-23 and Figure 5-24:
Lay the blade on a flat surface and check for distortion.
Replace any distorted blade.
Do not re-use spindle bolts which have stripped, worn or
undercut threads. Refer to "Torque Values Chart" on
page 59 when replacing hardware for proper torque.
!
WARNING
When mounting blades, rotate them after installation to ensure
blade tips do not touch each other or sides of the mower.
!
WARNING
Failure to correctly torque the bolt may result in the loss of the
blade which can cause serious injury.
Warped Blade (Replace)
Straight Blade
24579
Comparison of Warped and Straight Blades
Figure 4-23
Cutting Edge
Twisted Blade (Replace)
Cutting Edge
Straight Blade
24579
End View of Blades, Twisted & Straight Blades
Figure 5-24
®
48 ZT60 & ZT72 Accu-Z Zero Turn Mowers 357-103M
Table of Contents
Cutting Plane
Cutting
Plane

Storage

Take the following steps when storing the mower at the
end of the season and when the unit will not be used for
long periods to ensure readiness for the next mowing
season.
IMPORTANT: Do not use a high pressure washer
on or around the hydraulic pumps and motors. Water
intrusion will result and void the pump and motor
warranty.
1. Remove all grass, dirt, trash and grease that may
have accumulated on the mower and moving parts.
2. Scrape off compacted dirt, trash and grass clippings
from the deck underside. A coating of oil may also be
applied to the deck underside to minimize oxidation.
3. Clean and touch up all scrapes with Land Pride spray
paint.
4. Check blades and blade bolts for wear and replace if
necessary.
5. Service air cleaner. See "Engine Air Filter" on
page 43.
6. Check thoroughly for any worn or damaged parts
that need replacing and order them from your
nearest Land Pride Dealer.
7. Thoroughly lubricate machine, according to
lubrication instructions.
8. Block mower up so weight is off tires.
NOTE: Do not deflate tires.
9. Protect battery from freezing temperatures.
Disconnect the negative ground wire from the battery
to reduce the chances of a slow electrical drain.
Occasionally recharging battery during storage will
extend battery life.
10. Prepare engine for storage as described below.
11. Store mower in a clean, dry place.
Preparation of Engine for Storage
When engine is to be unused for long periods, proceed
as follows:
1. Run engine for a minimum of 15 minutes.
2. Drain oil from crankcase while engine is still warm.
3. Refill with fresh oil of proper viscosity.
4. Drain fuel tank and run engine until it stops from lack
of fuel. Gasoline evaporates if left in carburetor for
long periods, forming gum and varnish deposits in
carburetor. These deposits will cause engine
flooding and loss of power.
5. Remove and replace fuel filter if not done in previous
100 hours.
9/03/10