Table of Contents
Advertisement
Section 2: Operating Procedures
Moving Mower with Stalled Engine
Refer to Figure 2-9:
Each hydro-drive is equipped with a bypass valve for the
purpose of moving the mower when the engine is
inoperable.To bypass the hydro-drives, pull out on the
bypass valve rods and lift them into the slot to lock in
position. Both bypass valve rods are located at the rear
of the engine platform.
The park lever must be down (OFF) to move the mower.
IMPORTANT: Do not tow the machine. Move it by
hand or use a winch and load it on a trailer.
IMPORTANT: Following repairs, always make
certain the two bypass valves are returned to their
operating position before operating the mower.
4/19/10
Table of Contents
Front of Mower Faces This Direction
Steering
Figure 2-8
Z44 & Z52 (S/N 472620 -526170) Accu-Z Razor
Bypass Valve Rods
Bypass Valve
Figure 2-9
®
Zero Turn Mowers 357-044M
23801
23643
15
Advertisement
Table of Contents
