Table of Contents
Advertisement
11. When writing is completed, "Vx61 DSP Flash finished!"
is displayed. (Fig. 10)
*
Then, check the version and checksum of the
firmware without turning off the power of the main
unit.
12. Select the DIAG menu "23-5. TI FLASH version". (Fig. 10)
Check the displayed firmware version is the same as
the written firmware version. (Fig. 10)
13. Select the DIAG menu "23-6. TI FLASH checksum".
(Fig. 10)
Check the displayed checksum is the same as the writ-
ten firmware checksum. (Fig. 10)
*
When the displayed firmware version and checksum
are different from written firmware version and
checksum, follow the steps from 1 to 10 of writing
firmware again.
14. End of "DSP_FLASHER.exe".
15. Disconnect the RS232C cross cable, RS232C conver-
sion adapter and flexible flat cable.
*
Then, initialize the main unit without turning off its
power.
16. Select the DIAG menu "9. FACTORY PRESET".
17. Select the "PRESET RSRV".
PRESET INHIBIT (Initialization inhibited) /
9.PRESET INHI
18. Turn off the power of main unit and disconnect the
power cable from the AC outlet.
RX-V861/HTR-6080/DSP-AX861SE/DSP-AX861
TI VER 05.04r3
TiSUM:D3CB7BB2
When writing is completed, "Vx61 DSP Flash finished!" is displayed.
Fig. 10
PRESET RESERVED (Initialization reserved) /
9.PRESET RSRV
27
Hide quick links:
Advertisement
Table of Contents
