Output Rectifier Assembly Test - Lincoln Electric POWER MIG SVM165-A Service Manual

F-25
Service and repair should be performed by only Lincoln Electric factory trained personnel.
Unauthorized repairs performed on this equipment may result in danger to the technician
or machine operator and will invalidate your factory warranty. For your safety and to avoid
electrical shock, please observe all safety notes and precautions detailed throughout this
manual.
If for any reason you do not understand the test procedures or are unable to perform the
test/repairs safely, contact the Lincoln Electric Service Department for electrical trou-
bleshooting assistance before you proceed. Call 1-888-935-3877.
TEST DESCRIPTION
This test will determine if the Output Rectifier is shorted. See the Oscilloscope
Waveforms section of this manual for normal and abnormal output waveforms.
MATERIALS NEEDED
3/8" Nut Driver
5/16" Nut Driver
1/2" Wrench
Power MIG 350 Wiring Diagram (See the Machine Schematic in this manual.
Analog Volt/Ohmmeter (If Digital Meter is used you must use in Diode Check Mode
TROUBLESHOOTING & REPAIR

OUTPUT RECTIFIER ASSEMBLY TEST

WARNING
Do not use Ohms Scale)
POWER MIG 350MP
F-25