Blue gear
4
Latches
3) Place the blue gear on the front right groove.
4) Place the white shaft on both sides of the back
White shaft
Tighten the film, then close the printer door.
1) Rotate the blue gear in the direction of the arrow
• If a slack remains, perform step 3-2) through 4-1) again.
Blue gear
2) Securely close the printer door by using both
• "
• If "
• The printer door should be closed to make copies
Installing the Thermal Transfer Film
grooves.
to take up the slack on the film.
hands until a click is heard.
" flashing on the Multi-Copy/Error Indicator will go
out.
Notes
" is still flashing after closing the printer door,
make sure that the thermal transfer film has been
installed properly and tightened.
properly. Confirm both latches are locked.
11