NOTE:
WLAN modules are designed with a notch to prevent incorrect insertion.
Graphics board
The graphics board is secured with two Torx screws. Removing it allows access to the webcam and
allows you to remove the main rear cover.
Figure 7-54
To remove the graphics board:
1.
Prepare the computer for disassembly (see
2.
Remove the access panel (see
3.
Remove the graphics heat sink (see
4.
Remove the two Phillips screws (1) that secure the board to the system board.
84
Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
Graphics board location
Access panel on page
Preparing to disassemble the computer on page
45).
Graphics heat sink on page
75).
40).