Converter Board - HP Compaq Elite 8300 Touch All-in-One Business Maintenance & Service Manual

Converter board

The converter board is located on the left side of the computer (viewed from behind) under the main
rear cover. It is secured with two Torx screws and has two connectors.
Use the same converter spare part for all display panels; however, you must change jumper settings on
the board based on the display panel.
Figure 7-40
To remove the converter board:
1. Prepare the computer for disassembly (see
2.
Remove the access panel (see
3. Disconnect the two cables from the board (1).
NOTE:
pull on the wires.
70 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
Converter board location
Access panel on page
Be careful not to damage the cables when disconnecting them from the board. Do not
Preparing to disassemble the computer on page
45).
40).