HP Compaq Elite 8300 Touch All-in-One Business Maintenance & Service Manual page 74

NOTE:
The lifetime of the lithium battery can be extended by plugging the computer into a live AC
wall socket. The lithium battery is only used when the computer is NOT connected to AC power.
HP encourages customers to recycle used electronic hardware, HP original print cartridges, and
rechargeable batteries. For more information about recycling programs, go to
recycle.
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
The battery can now be seen on the lower right side of the fan.
Figure 7-32
3. To release the battery from its holder, squeeze the metal clamp that extends above one edge of
the battery. When the battery pops up, lift it out (1).
4. To insert the new battery, slide one edge of the replacement battery under the holder's lip with the
positive side up. Push the other edge down until the clamp snaps over the other edge of the
battery (2).
Figure 7-33
64 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
Access panel on page
Locating the battery
Removing and Replacing a coin cell battery (Type 2)
Preparing to disassemble the computer on page
45).
http://www.hp.com/
40).