Yamaha RX-V461 Service Manual page 12

3. SPEAKER SET
The analog switch settings for each sub-menu are as
shown in the table below.
LARGE: This mode is used for a speaker with high
bass reproduction performance (a large unit).
Full bandwidth signals are output.
SMALL: This mode is used for a speaker with low bass
reproduction performance (a small unit).
The signals of 90 Hz or less are mixed into
the channel specified by LFE/BASS.
NONE: This mode is used for no center speaker.
The center content is reduced by 3 dB and
distributed to FRONT L/R.
SWFR: LFE of 5.1 ch signal or LFE/BASS lower than
90 Hz is output through SUBWOOFER OUT.
FRONT: LFE of 5.1 ch signal or LFE/BASS lower
than 90 Hz is distributed to FRONT L/R.
3.FRNT:SML 0dB
3.CENTER NONE
3.LFE/B:FRNT
3.TONE:MAX
3.TONE:MIN
INPUT: DVD ANALOG
SPEAKER OUT: 1 kHz, SUBWOOFER OUTPUT: 50 Hz
Sub-menu Input level
FRONT : SML 0dB Both ch, -20 dBm
CENTER : NONE Both ch, -20 dBm
LFE/B : FRNT Both ch, -20 dBm
TONE : MAX Both ch, -20 dBm
TONE : MIN Both ch, -20 dBm
FRONT : SML 0dB SMALL
CENTER : NONE LARGE
LFE/B : FRNT LARGE
TONE : MAX LARGE
TONE : MIN LARGE
FRONT: SML 0dB
The FRONT L/R signal, when 90 Hz or lower, is mixed to the channel specified by LFE/BASS.
CENTER: NONE
The CENTER signal is distributed to FRONT L/R.
LFE / BASS: FRONT
The LFE (SUBWOOFER) signal is distributed to FRONT L/R.
TONE: MAX
The signal is output with the tone control [BASS +10 dB, TREBLE + 10 dB].
TONE: MIN
The signal is output with the tone control [BASS -10 dB, TREBLE - 10 dB].
Volume
FRONT
+6.0 dB +11.5 dBm
+6.0 dB +11.5 dBm
+6.0 dB +11.5 dBm
+6.0 dB +14.5 dBm
+6.0 dB +8.5 dBm
RX-V461/HTR-6040/DSP-AX461
LARGE LARGE SWFR
NONE LARGE SWFR
SMALL SMALL FRONT
LARGE LARGE SWFR
LARGE LARGE SWFR
SPEAKER OUT
CENTER SURROUND
-∞
-∞
-∞
-∞
-∞
SUBWOOFER
OUTPUT
-∞ -3.5 dBm
-∞ -∞
-∞ -∞
-∞ -∞
-∞ -∞
25