Wireless Stroboscopic Flash - Canon Speedlite 550EX Instructions Manual

Wireless Manual Flash With Varied Flash Output
7
Press Ihe <+> or < > button to sel
~pm
2'imm
Ihe flash output for B.
-I/B-::'
M
"~.,,~-~!~
8
Press the < SELISET > button.
'f!
• C and the flash output display wil l blink.
9©M
.n' ....
ZOOM
©
n ".
, 1 ,50
IQY:dQll).. 2'imm
9
Press the < + > or < - > button to set
7I,~-
, '"
the flash output for C.
"
"'Zo'
1lImI1 ""l~'
10
Press the < SEL /SET > button to
'~, '
register the settings.
9~
"
.
-~-
®
."C9}
~
If there are on ly two slave units (A and B), steps 9 aoo 10 may be omitted.
Mer you complete the settings, you can check the respective flash output for slave
units A. B. and C by pressing the",
+
>
or '" -
>
button.
Press the master unit's pilot lamp to test fire the slave units.
[4] Wireless Stroboscopic Flash
After selling up the wireless flash system, you can set stroboscopic flash with
the master unit for wireless stroboscopic flash.
The firing frequency and flash count wi ll be the same for all stave units. They can
be
set by
lollowing the procedure on page 46.
Set the flash output of the stave units in the same way as for wireless manuat flash. See page 71 .
To determine the proper exposure, take lest shots and experiment.
73