Input the user name and password that ISP (Internet service provider) provides. After saving it reboot up your system. Then the DVR will build a
network connection based on PPPOE. The IP address will change into dynamic IP address above operation is well done.
Operation: After PPPOE dialing successfully look up the IP address in the [IP address] and obtain the current IP address. Then use this IP address to
visit the DVR through user port.
[NTP setup]
The NTP server must be installed in the PC.
Picture 4.18 NTP setup
Picture 4.19 EMAIL setup
Host computer IP: Input the IP address installed NTP server.
Port: Default 123. You can set the port according to NTP server.
Time zone: London GMT+0, Berlin GMT+1, Cairo GMT+2, Moscow GMT+3, New Delhi GMT+5, Bangkok GMT+7, Hong Kong Beijing
GMT+8, Tokyo GMT+9, Sydney GMT+10, Hawaii GMT-10, Alaska GMT-9, Pacific time GMT-8, American mountain time GMT-7, American mid
time GMT-6, American eastern time GMT-5, Atlantic time GMT-4, Brazil GMT-3, Atlantic mid time GMT-2.
Update cycle: The same with the NTP server check interval. Default: 10 minutes.
[DDNS] It is the abbreviation of dynamic domain name server.
Local domain name: Provide the domain name registered by DDNS.
User name: Provide the account registered by DDNS.
Password: Provide the password registered by DDNS. When the DDNS is successfully configured and start, you can connect the domain name in
the IP address.
Note: The DNS must be configured in the network setup.
Picture 4.20 IP purview setup
29
Digital Video Recorder: User Manual