Lincoln Electric IM536-D Operator's Manual page 18

B-4
FIGURE B.3
Wire Spindle Shaft
To wire drive
Note: The brake should be adjusted with a spool of
wire installed. When properly adjusted it should
move freely but not coast.
Friction Brake Adjustments
1. With wire spool installed, check free movement
and coast of the spool.
2. To tighten the brake turn the wing nut clockwise in
1/4 turn increments until coasting stops.
3. To loosen the brake turn the wing nut counter-
clockwise in 1/4 turn increments until the wire
spool moves freely without coasting.
Wire Threading
Refer to Figure B.4
1. Release the Spring Loaded Pressure Arm (1)
rotate the Idle Roll Arm (2) away from the Wire
Feed Drive Roll (3). Ensure that the visible, sten-
ciled size on the drive roll matches the wire size
being used.
2. Carefully detach the end of the wire from the
spool. To prevent the spool from unwinding, do
not release the wire until after step 5.
3. Cut the bent portion of wire off and straighten the
first 4" (100 mm).
4. Thread the wire through the In-going guide tube
(4), over the drive roll (3), and into the out-going
guide tube (5).
5. Close the idle roll arm and latch the spring loaded
pressure arm (2) in place (now you may release
the welding wire).
SP-125 PLUS
OPERATION
4" Wire Spool
2
Wing Nut
and Spacer
6. The idle roll pressure adjustment wing nut is nor-
When inching the welding wire, the drive rolls, the
gun connector block and the gun contact tip are
always energized relative to work and ground and
remain energized several seconds after the gun
trigger is released.
7. Refer to Figure B.5. Remove gas nozzle and con-
10. Depress the gun trigger switch and feed welding
11. Replace contact tip and gas nozzle.
12. Refer to Figure B-6. Cut the wire off 1/4" – 3/8"
FIGURE B.4
4
5
3
mally set for mid-position on the pressure arm
threads. If feeding problems occur because the
wire is flattened excessively, turn the pressure
adjustment counter-clockwise to reduce distortion
of the wire. Slightly less pressure may be required
when using 0.023 – 0.025" (0,6 mm) wire. If the
drive roll slips while feeding wire, the pressure
should be increased until the wire feeds properly.
WARNING
tact tip from end of gun.
8. Turn the SP-125 Plus ON ("I").
9. Straighten the gun cable assembly.
wire through the gun and cable. (Point gun away
from yourself and others while feeding wire.)
Release gun trigger after wire appears at end of
gun.
(6 – 10 mm) from the end of the tip. The SP-125
Plus is now ready to weld.
1
The Wire Drive Feed Roll can
accommodate two wire sizes by
flipping the wire drive feed roll
over. The sizes are stenciled on
the drive roll.