Finish Installation - NuTone CFH52BS Installation Manual

FINISH INSTALLATION

1. Swing the motor assembly up into position under the mounting
bracket. Secure the bracket to the plate with the screws provided.
(Fig. 9)
2. Carefully lift the motor housing onto the mounting bracket, properly
align the holes and tighten the motor housing with the 4 screws
supplied. (Fig. 10)
ATTACH FAN BLADES
Your fan is equipped with 2-sided reversible blades. Select the finish and
install the blade brackets over the side of the blades that will be visible.
1. Attach the blade to the blade bracket using the screws and fiber
washers as shown in Figure 11. Start screw into bracket. Repeat
for the two remaining screws.
2. Tighten each screw. Make sure the blade is straight.
3. Fasten blade assembly to motor using the screws supplied. (Fig.
11)
MODELS CFH52BS • CFH52PB • CFH52RB • CFH52WH
MOTOR
MOUNTING
BRACKET
MOTOR
HOUSING
MOUNTING
BRACKET
SCREWS
FIGURE 9
SCREWS
FIGURE 10
SCREWS
BLADE
BLADE BRACKET
FIGURE 11
Page 5
SCREWS
FIBER
WASHERS